The G9 DSM-26 Digital Speaker Management System has been designed to give all the features and control that you need for setting up and running a sound system. Whether it is a fixed installation, or for use on the road the DSM-26 can handle all requirements for the management of a 2 input / 6 output audio system.

The system is based on a sampling frequency 24bit, 64KHz delta - sigma A/D and D/A converter, with a 32 bit floating point DSP for the signal processing. Operation is through connection to a Windows based computer (Windows 98 or above) via a USB 2 interface. There are 2 x analogue XLR input channels (IN1 + IN2), plus a balanced stereo jack connection. You can also Mono the input stages (IN1+IN2). On each of the two channels of the input stage you can select; DELAY, PEQ, GAIN and MUTE characteristics. You can then route these signals to the 6 outputs of A, B, C, D, E and F in a variety of combinations. After the source selection has been made linking input signal to the chosen outputs, you can then introduce DELAY, select crossover points with the Hi Pass and Low Pass filters choosing Butterworth, Bessel or Linkwitz Riley filter characteristics. Parametric EQ can also added, as well as GAIN, LIMITER settings and of course MUTE for each output channel.




The DSM 26 has 50 memories that are set up by using an external computer via USB.  Output LED indication:
Each channel output on the DSM 26 gives status of audio source and output level. It also indicates whether a Limiter is in or out of circuit.

Master LED indication:
PROGRAM - When LED lit it will also show the memory number loaded.
STATUS - This confirms that the indications on each output channel is current.
REMOTED - Shows connection to external computer, while Indicating ID number in the numeric window.


      


             

Connections	Input	Output
Connectors:	2 x XLR - 3 pin	6 x XLR - 3 pin
	1 x 6.35 Jack socket (BGM signal)
Impedance:	10K Ohm	47 Ohm (Load: > 600 Ohm)
Maximum Level:	+ 20 dBu	+ 20 dBu

 

Frequency Response:	20Hz - 20KHz +0.3 / -0.3dB
	10Hz - 30KHz +0.3 / - 3.0dB
S/N Ratio:	110dB (A weighted)
THD + Noise:	< 0.006%
System min delay:	1.2ms (signal output settings at “0”)
Remote Control:	USB 2 / RS 485
Dimensions:	482 x 44.8 x 228mm
Weight:	4.7 Kg

 
DSM-26 digital speaker management system.pdf